Bowling alley install.... Helped out and did my first multi swm 16 install
manuals.solidsignal(dot)com/Multiswitch%20White%20Paper(dot)pdf cant post links since Im too new
The white pages from solid signal were awesome....
an now my DECA question
My 4 leads from the dish are home run to the panel
My four leads from the groups of receivers (100 feet out in the drop ceiling) are home run to the panel
I have them clustered in 8 7 6 3 using 3 qty 8 ways and a 1 qty 4 way splitter (ALL GREEN LABEL DIRECTV approved splitters)
I followed page 8 diagram to a T
I had someone tell me I could use the SWM1 / PWR outs to a splitter and inject my DECA there. I tried this have 18/24 boxes working on the ipad app.
6 fail to show up on the ipad app
all boxes are names, shared and set for allow.
1 box fails to even say its part of whole home and only shows me 1 option in control and not to share what is being viewed.
Feel like I tried something too ambitious for a first time.
Any help on where I can straighten out my app issues.
Also when activating all 24 boxes at once, is it normal to have to do a few boxes at a time instead of all at once... I noticed all 1-8 started well then boxes 9-15 showed some satellites missing in the check mark boxes, but activated fine after the first 8 were done....
N
manuals.solidsignal(dot)com/Multiswitch%20White%20Paper(dot)pdf cant post links since Im too new
The white pages from solid signal were awesome....
an now my DECA question
My 4 leads from the dish are home run to the panel
My four leads from the groups of receivers (100 feet out in the drop ceiling) are home run to the panel
I have them clustered in 8 7 6 3 using 3 qty 8 ways and a 1 qty 4 way splitter (ALL GREEN LABEL DIRECTV approved splitters)
I followed page 8 diagram to a T
I had someone tell me I could use the SWM1 / PWR outs to a splitter and inject my DECA there. I tried this have 18/24 boxes working on the ipad app.
6 fail to show up on the ipad app
all boxes are names, shared and set for allow.
1 box fails to even say its part of whole home and only shows me 1 option in control and not to share what is being viewed.
Feel like I tried something too ambitious for a first time.
Any help on where I can straighten out my app issues.
Also when activating all 24 boxes at once, is it normal to have to do a few boxes at a time instead of all at once... I noticed all 1-8 started well then boxes 9-15 showed some satellites missing in the check mark boxes, but activated fine after the first 8 were done....
N